Journal Home Online First Current Issue Archive For Authors Journal Information 中文版

2008, Volume 3, Issue 3

Abstract

Keywords

Related Research

Back to Top

Frontiers of Mechanical Engineering >> 2008, Volume 3, Issue 3 doi: 10.1007/s11465-008-0067-5

Contact of surfaces and contact characteristics of offset surfaces

School of Mechanical Engineering, Dalian University of Technology

Available online: 2008-09-05
HTML15 PDF 0 Collect 0

Next Previous

Abstract

Based on differential geometry, the contact problems of two surfaces are discussed in this paper. The relationship between the contact status of two surfaces and that of offset surfaces are also analyzed. For a 5-axis NC machining, some research such as optimization of cutter location and calculation of the geometrical cusp height are important. The research results indicate that the relative normal curvature is an important geometrical invariant for describing the contact state of two surfaces. For point contact two surfaces, the calculation equation for the second order remained error is given. For line contact two surfaces, the condition of the second order line contact is that the principal directions and curvatures of the two surfaces are the same along the contact curve. If two surfaces keep the second order line contact, their two offset surfaces will also keep the second order line contact, and their third order remained errors are also uniform with that of the two offset surfaces.

Related Research