Frontiers in Energy
>> 2008,
Volume 2,
Issue 3
doi:
10.1007/s11708-008-0026-1
Elastoplastic frictional contact problem study
on interference fits of compressor
| 1.State Key Laboratory of Structural Analysis for Industrial Equipment, Department of Engineering Mechanics, Dalian University of Technology; 2.College of Urban Railway Transportation, Shanghai University of Engineering Science |
Available online: 2008-09-05
Next
Previous
Abstract
The FE parametric quadratic programming (PQP) method developed from the parametric variational principle (PVP) was used for the analysis of the stress distribution of the 3D elastoplastic frictional contact of an impeller-shaft sleeve-shaft. A locomotive-type turbocharger compressor with 24 blades under combined centrifugal and interference-fit loading was considered in the numerical analysis. The solution of elastoplastic frictional contact problems belongs to unspecified boundary problems where the interaction between two kinds of nonlinearities should occur. To save time in the numerical computation, a multi-substructure technique was adopted in the structural modeling. The effect of fit tolerance, wall thickness of the shaft sleeve, and rotational speed on the contact stress was discussed in detail in the numerical computation. To decrease the difficulty of the assembly process and ensure the safety of the working state, the amount of interference between the shaft sleeve and shaft by press-fitting should be controlled strictly to avoid the rapid increase of contact stress. The numerical results show that the algorithm has high accuracy and good convergence. The study can be referred to in deciding the proper fit tolerance and improving the design and manufacturing technology of compressor impellers.
京公网安备 11010502051620号
