2005, Volume 7, Issue 6
Strategic Study of CAE >> 2005, Volume 7, Issue 6
DSM Applied to Planning Process in Cooperative Design for Complex Products
1. National ClMS Engineering Research Center , Tsinghua University , Beijing 100084 , China
2. School of Mechanical Engineering , Jiangsu University , Zhenjiang , Jiangsu 212013 , China
Next Previous
Abstract
The paper applied the matrix to the cooperative design for complex products, described the design flow diagram with design structure matrix (DSM), then reset the planning process according to analyzing and partitioning the DSM in order to shorten the cycle of design and reduce the cost of development.
Keywords
DSM (design structure matrix) ; analysis ; partition ; planning
Figures
图1
图2
图3
图4
图5
图6
图7
References
[ 1 ] 熊光楞.并行工程的理论与实践[M].北京:清华大学出版社, 2000
[ 2 ] 李伯虎, 柴旭东, 朱文海.复杂产品协同制造支撑环境技术的研究[J].计算机集成制造系统———CIMS , 2003, (8) :691～697 link1
[ 3 ] MohanSN , Managingunmannedflightprojectsusingmethodsincomplex productdevelopment[J].AerospaceConferenceProceedings, IEEE , 2002, (7) :3473～3488
[ 4 ] DavidM , IdelmerfaaZ , RichardJ.Organizationmethodforcomplexcooperativedesignprojects[A].Systems, ManandCybernetics[C].2002IEEEInternationalConference, 2002, (4) :61～64
[ 5 ] ActonDE , OldsJR .Computationalframeworksforcollaborativemultidisciplinarydesignofcomplexsystems[A].AmericanInstituteAeronauticsandAstronautics (AIAA) InternationalConference[C], 1998
[ 6 ] HyunJeongChoo, HammondJ, TommeleinID , etal.DePlan:atoolforintegrateddesignmanagement[J].AutomationinConstruction, 2004, (13) :313～326
京公网安备 11010502051620号
