期刊首页 优先出版 当期阅读 过刊浏览 作者中心 关于期刊 English

2022年 第17卷 第3期

摘要

关键词

相关研究

回顶部

《机械工程前沿（英文）》 >> 2022年 第17卷 第3期 doi: 10.1007/s11465-022-0689-z

Method for solving the nonlinear inverse problem in gas face seal diagnosis based on surrogate models

State Key Laboratory of Tribology in Advanced Equipment, Tsinghua University, Beijing 100084, China;State Key Laboratory of Tribology in Advanced Equipment, Tsinghua University, Beijing 100084, China;State Key Laboratory of Tribology in Advanced Equipment, Tsinghua University, Beijing 100084, China;State Key Laboratory of Tribology in Advanced Equipment, Tsinghua University, Beijing 100084, China;State Key Laboratory of Tribology in Advanced Equipment, Tsinghua University, Beijing 100084, China;State Key Laboratory of Tribology in Advanced Equipment, Tsinghua University, Beijing 100084, China

收稿日期： 2021-09-13 发布日期： 2021-09-13
HTML23 PDF 0 收藏 0

下一篇 上一篇

摘要

Physical models carry quantitative and explainable expert knowledge. However, they have not been introduced into gas face seal diagnosis tasks because of the unacceptable computational cost of inferring the input fault parameters for the observed output or solving the inverse problem of the physical model. The presented work develops a surrogate-model-assisted method for solving the nonlinear inverse problem in limited physical model evaluations. The method prepares a small initial database on sites generated with a Latin hypercube design and then performs an iterative routine that benefits from the rapidity of the surrogate models and the reliability of the physical model. The method is validated on simulated and experimental cases. Results demonstrate that the method can effectively identify the parameters that induce the abnormal signal output with limited physical model evaluations. The presented work provides a quantitative, explainable, and feasible approach for identifying the cause of gas face seal contact. It is also applicable to mechanical devices that face similar difficulties.

相关研究