期刊首页 优先出版 当期阅读 过刊浏览 作者中心 关于期刊 English

2014年 第8卷 第2期

摘要

关键词

相关研究

回顶部

《化学科学与工程前沿（英文）》 >> 2014年 第8卷 第2期 doi: 10.1007/s11705-014-1431-0

WO3 nanomaterials synthesized via a sol-gel method and calcination for use as a CO gas sensor

1. Department of Materials and Metallurgical Engineering, Institut Teknologi Sepuluh Nopember (ITS), Surabaya 60111, Indonesia.2. Department of Mechanical Engineering, Surabaya State Shipbuilding Polytechnic, Institut Teknologi Sepuluh Nopember (ITS), Surabaya 60111, Indonesia.3. Department of Materials Science and Engineering, National Taiwan University of Science and Technology (NTUST), Taipei 10607, Taiwan, China.4. Department of Electronic Engineering, National Taiwan University of Science and Technology (NTUST), Taipei 10607, Taiwan, China

发布日期： 2014-05-22
HTML21 PDF 1 收藏 0

下一篇 上一篇

摘要

Carbon monoxide is a poisonous and hazardous gas and sensitive sensor devices are needed to prevent humans from being poisoned by this gas. A CO gas sensor has been prepared from WO synthesized by a sol-gel method. The sensor chip was prepared by a spin-coating technique which deposited a thin film of WO on an alumina substrate. The chip samples were then calcined at 300, 400, 500 or 600 °C for 1 h. The sensitivities of the different sensor chips for CO gas were determined by comparing the changes in electrical resistance in the absence and presence of 50 ppm of CO gas at 200 °C. The WO calcined at 500 °C had the highest sensitivity. The sensitivity of this sensor was also measured at CO concentrations of 100 ppm and 200 ppm and at operating temperatures of 30 and 100 °C. Thermogravimetric analysis of the WO calcined at 500 °C indicated that this sample had the highest gas adsorption capacity. This preliminary research has shown that WO can serve as a CO gas sensor and that is should be further explored and developed.

相关研究