Strategic Study of CAE >> 2009, Volume 11, Issue 4
Trends of process parameters impact on forming quality of part during the gas-assisted injection molding
Key Laboratory for Mechanical Manufacture & Automation of Ministry of Education, Zhejiang University of Technology, Hangzhou 310032,China
Next Previous
Abstract
This paper investigates process optimization for the specific rib with section s-3 during the gas-assisted injection molding firstly, which is to get relationship between process parameters and quality evaluations,based on the Taguchi experimental design. Then, in the light of the above process conditions, a comparative study of four different cross-section ribs are done, to investigate trend of the impact of the single process parameter on forming quality, by changing one of the parameters while the others remain unchanged.
Keywords
gas-assisted injection molding ; rib ; Taguchi experiment design
References
[ 1 ] 柳和生,魏常武,周国发.气体辅助注射成型中气道截面对气体穿透的影响[J].塑料,2004,33(3):15-20 link1
[ 2 ] 陈立恒,梁继才,李义.气体辅助注射成型工艺参数对成型结果的影响[J].模具工业,2006,32(9):45-49 link1
[ 3 ] Parvez M A ,Ong N S,Lam Y C.Gas -assisted injection mold- ing: the effects of process variables and gas channel geometry[ J] . Journal of Materials Processing Technology, 2002 , 121 :27 -35 link1
[ 4 ] Chen Shiachung, Hu Shengyan,Jong Wenren.Integrated simula- tions of structural performance, molding process, and warpage for gas -assisted injection -molded parts.III.simulation of cyclic, transient variations in mold wall temperatures[ J] .Journal of Ap- plied Polymer Science, 1999 , 71 : 339 – 351 link1
[ 5 ] Chen Shiachung , Hu Shengyan, Huang Jengsheng.Investigation of gas -assisted injection molding.Part III : effect of gas channel design on part bending strength [ J ] .Polymer Engineering And Science, 1998 , 38 ( 7 ) : 1085 -1098 link1
[ 6 ] Rean Derchien, Chen Shiachung, Lin Mingchung, et al.Effect of gas channel design on the molding window of gas -assisted -injec- tion -molded polystyrene parts [ J] .Journal of Applied Polymer Science, 2003 , 90 : 2979 – 2986 link1
[ 7 ] Nie Y Y, Turng L S, Wang K K .Structural analysis for gas -as- sisted injection molded parts[ J] .Adv in Polym Techn,1997 , 16 : 159 – 173 link1